Density Fluctuation At The Trailing Edge (When Using Thick Paper) - Ricoh Pro C9100 Operating Instructions Manual

Density Fluctuation at the Trailing Edge (When Using Thick Paper)

The trailing edge is fainter or denser when using thick paper.
Cause:
This may occur if:
• Printing is done at low temperature or humidity
• Halfttone printing
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Specifying the area to be adjusted
1. Measure by a ruler or other device the length (in mm) of the area from the trailing edge of
the paper where the print is faint or dense.
10 mm
(0.4 in.)
DFT059
Uneven Density
73