Double Feeding - Ricoh Pro C9100 Operating Instructions Manual

<If custom paper is not used>
In the [Machine: Image Position] group on the [Adjustment Settings for Skilled Operators]
menu, set 0104: [Skew Detection] to [Off].
An envelope is used.
If an envelope flap at the trailing edge is oblique, a skew may be wrongly detected when the envelope
is transferred with its flap open.
Disable skew detection function.
<If custom paper is used>
In [Advanced Settings] for the custom paper, set 015: [Skew Detection] to [Off].
<If custom paper is not used>
In the [Machine: Image Position] group on the [Adjustment Settings for Skilled Operators] menu, set
0104: [Skew Detection] to [Off].
The skew detection level is too high.
In the [Machine: Image Position] group on the [Adjustment Settings for Skilled Operators] menu, select
0105: [Skew Detection Level] and increase the value.
• Disabling the skew detection function will allow skewed printing. If this is not acceptable, contact
your service representative.

Double Feeding

Depending on the cause of the problem, do one of the following:
Have you ruffled the paper sufficiently?
Double feeding may result if the paper is not ruffled properly.
Remove the paper, ruffle it, and reload it.
For details about ruffling the paper, see "Fanning the Paper", About This Machine.
The edges of the sheets are rough.
Turn the sheets the other way up or smooth the edges before loading.
Two-tray wide LCT (Vacuum Feed LCIT RT5100) is used.
The factory-set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Troubleshooting Paper Delivery Problems
109