7. Image Quality Problem: Full Page
• After performing the solution, it is recommended to perform the color calibration of the external
controller. For details see, page 159 "Operating Procedure for Color Calibration".
Uneven Gloss: Wavy
When duplex printing is performed on paper whose paper thickness level is between 1 and 4, wavy
density fluctuations may occur on side 2.
Cause:
When printing solid fill or other image that consumes lots of toner, the fusing unit temperature rises,
affecting the paper separation from the pressure roller, resulting in glossiness.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Paper Settings.
Solution:
Carry out the following sequence of procedures. Terminate the sequence as soon as the problem is
resolved.
Procedure 1: Decrease the nip width
1.
In [Advanced Settings] for the custom paper, set 092: [Fusing Nip Width Setting] to "3".
2.
Print the image. Has the problem been resolved?
Yes
Finished!
No
Set 092: [Fusing Nip Width Setting] to "2".
84
DFT042