White Spots On A Textured Surface - Ricoh Pro C9100 Operating Instructions Manual

<If the area within 107 mm (4.2 inches) of the trailing edge is fainter>
1. In [Advanced Settings] for the custom paper, check the present value in 016: [Transfer
Timing Roller Feed Speed]. Is it higher than +0.5%?
Yes Contact your service representative.
No Increase the value by 0.1 percentage point.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even though you have increased the
value to +0.5%, contact your service representative.
<If the area within 107 mm (4.2 inches) of the trailing edge is denser>
1. In [Advanced Settings] for the custom paper, check the present value in 016: [Transfer
Timing Roller Feed Speed]. Is it lower than -0.5%?
Yes Contact your service representative.
No Decrease the value by 0.1 percentage point.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even though you have decreased the
value to -0.5%, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller. For details see, page 159 "Operating Procedure for Color Calibration".

White Spots on a Textured Surface

White spots appear on indentations.
Uneven Density
79