Adjusting The Image Position On Side 2 - Ricoh Pro C9100 Operating Instructions Manual

A
In the 01: [Machine: Image Position] group on the [Adjustment Settings for Skilled Operators]
menu, adjust the image position.
• 0101: [Image Position: Across Feed]
• 0102: [Image Position: With Feed]

Adjusting the Image Position on Side 2

If you want to align an image position on Side 2 to an image position on Side 1 that has been adjusted,
see page 168 "Aligning the Image Position on Side 2 to That on Side 1 (Using a Template to Align the
Image Position on Side 1 and 2)".
<If custom paper is used>
Perform the solution described in "(a) Adjust the image skew", "(b) Adjust the image position (If
custom paper is used)", "(c) Adjust the magnification (Across feed direction)" and then "(d) Adjust
the magnification (With feed direction)".
<If custom paper is not used>
Perform the solution described in "(a) Adjust the image skew", "(e) Adjust the image position (If
custom paper is not used)"
• You cannot adjust the vertical magnification and horizontal magnification of all types of paper
other than custom paper. Therefore, it is recommended to pre-register the type of paper in use as a
custom paper.
• For details about specifying settings, see "Details of Menu Items in Adjustment Settings for Skilled
Operators" and "Details of Menu Items in Advanced Settings", Adjustment Item Menu Guide.
• If the problem persists even though you have adjusted the setting to its maximum and minimum
values, contact your service representative.
• If it is difficult to check and adjust the image position on the printed sheet, print one side of the
format used in page 168 "Aligning the Image Position on Side 2 to That on Side 1 (Using a
Template to Align the Image Position on Side 1 and 2)".
Adjusting the Image Position of the Either Side of the Paper
DFP492
165