Higher Density At The Leading Edge - Ricoh Pro C9100 Operating Instructions Manual

3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3. If the problem persists even though you have increased the value
in 0203: [Maximum Image Density] to "5", contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller. For details see, page 159 "Operating Procedure for Color Calibration".

Higher Density at the Leading Edge

The area within approximately 65 mm (3.5 inches) from the leading edge of the image or at the trailing
edge of the blank area is dense.
65 mm (3.5 in.)
65 mm (3.5 in.)
Cause:
Printing is done at low temperature or humidity.
Solution:
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No In the 02: [Machine: Image Quality] group on the [Adjustment Settings for Skilled
Operators] menu, select 0201: [Adjust Image Density/ DEMS] and execute [Image
Density Adjustment: Manual Execute].
DFT060
Uneven Density
77