Sheets Cannot Be Stapled Properly - Ricoh Pro C9100 Operating Instructions Manual

If this happens, stapled sheets, when delivered, may push the previously delivered sheet, resulting in
paper bending or misfeeding.
This may occur if:
• There is a tight curl on a delivered set of stapled sheets.
• Limp paper such as thin or recycled paper is used.
Trailing edge
too near exit
Output tray
Paper feed direction
Solution:
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. In the 03: [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Skilled
Operators] menu, set 0301: [Adjust Paper Curl] to [Adjust
Select "Strong", "Medium" or "Weak" to control the level of decurling as required.
4. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.

Sheets Cannot Be Stapled Properly

Cause:
When the sheets are fed to the staple unit inside the finisher, they may be overlaid, resulting in a
misalignment of 5 mm (0.2 inches) relative to each other after stapling.
Paper exit
CEZ593
Curl].
Finisher
129