Table of Contents
Advertisement
TRANSMISSION - NGC
P0736-GEAR RATIO ERROR IN REVERSE —
TEST
2
With the DRBIII , read Transmission DTC's.
If any of these DTC's are present, perform their respective tests first.
Are there any Loss of Prime, Line Pressure Sensor and/or Speed Sensor DTCs
present?
Yes → Refer to the Transmission category and perform the appropriate
→ Go To 3
No
3
With the DRBIII , perform the Reverse Gear Clutch test. Follow the instructions on
the DRBIII .
Increase the throttle angle or TPS Degree to 30° for no more than a few seconds.
CAUTION: Do not overheat the transmission.
Did the clutch test pass - Input Speed remain at zero?
Yes → Go To 4
→ Go To 5
No
4
The conditions to set this DTC are not current at this time.
Check the gearshift linkage adjustment.
Gear ratio DTC's can be set by problems in the Input and Output Speed Sensor
circuits. If the vehicle passes the clutch test and still sets gear ratio DTC's, check the
Speed Sensors for proper operation.
Remove the Starter Relay.
With the DRBIII , check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Check the Speed Sensor wiring and connectors for good connection, then perform a
wiggle test using the Transmission Simulator, Miller tool #8333 and Electronic
Transmission Adapter kit, Miller tool #8333-1.
This DTC can also be set under extreme temperature conditions, this is usually
caused by an internal problem. Verify if the problem is only experienced under
extreme hot or cold conditions.
With the DRBIII , check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Were there any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
5
If there are no possible causes remaining, view repair.
Repair
ACTION
symptom. If any of these DTC's are present, they will cause a gear
ratio error. Perform the test for Loss of Prime first if it is present.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Repair internal transmission per the Service Information. Check
all of the components related to the Reverse and LR clutches.
Inspect the Oil Pump and repair or replace per the Service
Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
Continued
70
APPLICABILITY
All
All
All
All
Advertisement
Table of Contents
