Table of Contents
Advertisement
Symptom:
MEMORY SWITCH SHORT - DDM
When Monitored and Set Condition:
MEMORY SWITCH SHORT - DDM
When Monitored: Continuously.
Set Condition: If the MUX circuit is under 0.10 volt for over 10 seconds, this code will set.
DTC PRESENT
DRIVER POWER SEAT SWITCH
MEMORY SELECT SWITCH MUX
DRIVER DOOR MODULE
TEST
1
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Operate the Seat Switch several times.
With the DRBIII , read DTCs.
Does the DRBIII display MEMORY SWITCH SHORT?
Yes → Go To 2
→ The condition that caused this code to set is not present at this
No
2
Disconnect the Driver Power Seat Switch connector.
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run and wait 10 seconds.
With the DRBIII , read DTCs.
Does the DRBIII display MEMORY SWITCH SHORT?
Yes → Go To 3
→ Replace the Driver Power Seat Switch.
No
POSSIBLE CAUSES
ACTION
time.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1.
875
POWER SEATS
APPLICABILITY
All
All
Advertisement
Table of Contents
