Table of Contents
Advertisement
8L - 30
LAMPS/LIGHTING - INTERIOR
GLOVE BOX LAMP SWITCH (Continued)
Fig. 5 GLOVE BOX LAMP SWITCH - REMOVE/
1 - GLOVE BOX LAMP SWITCH
2 - GLOVE BOX LAMP SWITCH CONNECTOR
3 - INSTRUMENT PANEL
4 - GLOVE BOX OPENING
INSTALLATION
(1) If replacing the lamp, push straight into glove
box lamp switch.
(2) Position lamp switch over retaining hole and
firmly snap into place (Fig. 5).
(3) Reach up behind instrument panel, and con-
nect the electrical connector.
(4) Close glove box.
(5) Close right door.
(6) Connect the battery negative cable.
(7) Close hood.
(8) Verify vehicle and system operation.
ILLUMINATION LAMPS
REMOVAL
The Instrument Panel Switch Pod has two illumi-
nation lamps (Fig. 6). If found to be faulty, the entire
cluster bezel must be removed. The Light Emitting
Diodes (LED's) are serviceable by turning 1/4 turn
counterclockwise to remove. The cluster bezel must
first be removed to service the LED's (Refer to 23 -
BODY/INSTRUMENT PANEL/CLUSTER BEZEL -
REMOVAL).
INSTALLATION
(1) Place Light Emitting Diode (LED) into lamp
opening in instrument panel switch pod.
(2) Turn 1/4 turn clockwise.
(3) Install Cluster bezel (Refer to 23 - BODY/IN-
STRUMENT PANEL/CLUSTER BEZEL - INSTAL-
LATION).
(4) Verify vehicle and system operation.
INSTALL
Fig. 6 INSTRUMENT PANEL SWITCH POD
ILLUMINATION
1 - INSTRUMENT PANEL SWITCH POD ILLUMINATION
LIFTGATE LAMP
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Open liftgate.
(3) Using a trim stick (special tool #C-4755) or
equivalent, gently pry out on door courtesy lamp lens
and remove from trim panel (Fig. 7).
Fig. 7 LIFTGATE LAMP LENS - REMOVAL
1 - LIFTGATE TRIM PANEL
2 - LIFTGATE LAMP UNIT LENS
3 - TRIM STICK (SPECIAL TOOL #C-4755)
(4) Gently pry up on the edge of the lamp and pull
out of the liftgate lamp unit to remove (Fig. 8).
CS
Advertisement
Table of Contents
