Table of Contents
Advertisement
CS
PARKING BRAKE CABLE - FRONT (Continued)
Fig. 77 Cable Removal From Lever Take-Up Reel
1 - FRONT CABLE BUTTON
2 - TAKE-UP REEL
Fig. 78 Wrench Positioned To Release Cable
1 - CABLE RETAINER
2 - 12-POINT BOX END WRENCH
3 - LEVER
(26) Place left rear parking brake cable button into
equalizer (Fig. 70). Release cables allowing button to
seat. It may take some hand pressure to completely
seat button.
(27) Lower vehicle.
(28) Unlock automatic adjuster in parking brake
lever. (Refer to 5 - BRAKES/PARKING BRAKE -
STANDARD PROCEDURE)
(29) Connect battery negative cable to battery
post.
(30) Adjust parking brake shoes. (Refer to 5 -
BRAKES/PARKING
MENTS)
Retainer
BRAKE/SHOES
-
ADJUST-
Fig. 79 Cable Installation Into Lever Take-Up Reel
1 - FRONT CABLE BUTTON
2 - TAKE-UP REEL
PARKING BRAKE CABLE -
LEFT REAR
REMOVAL
(1) Lock out automatic adjuster in parking brake
lever. (Refer to 5 - BRAKES/PARKING BRAKE -
STANDARD PROCEDURE)
(2) Raise and support vehicle. (Refer to LUBRICA-
TION & MAINTENANCE/HOISTING - STANDARD
PROCEDURE)
NOTE: It may be necessary to back off parking
brake shoe adjustment to allow sufficient slack to
disengage cable buttons from connectors in follow-
ing step.
(3) Slide left rear cable button inboard and remove
from equalizer (Fig. 70).
(4) Access and remove rear hub and bearing.
(Refer to 2 - SUSPENSION/REAR/HUB / BEARING -
REMOVAL)
(5) Remove parking brake cable bolt at knuckle
(Fig. 80).
(6) Remove parking brake shoes from support.
(Refer to 5 - BRAKES/PARKING BRAKE/SHOES -
REMOVAL)
(7) Remove shoe actuator from end of cable and
support (Fig. 81).
(8) Pull cable out of support plate and knuckle.
(9) Place a 13 mm 12-point box wrench over cable
retainer on end of cable housing at crossmember and
collapse retainer fingers (Fig. 82).
(10) Remove cable.
BRAKES 5 - 43
Advertisement
Table of Contents
