Table of Contents
Advertisement
CS
DISC BRAKE CALIPER - REAR (Continued)
Fig. 33 Installing Caliper Guide Pin Bushing
1 - CALIPER
2 - BUSHING
Fig. 34 Bushing Correctly Installed In Caliper
1 - BUSHING
2 - CALIPER
3 - BE SURE BOTH BUSHING FLANGES ARE FULLY SEATED
AROUND CALIPER BUSHING BORES.
Fig. 35 Installing Sleeve In Bushing
1 - CALIPER
2 - SLEEVE
3 - BUSHING
(6) While holding convoluted boot on opposite end
of bushing, push steel sleeve through bushing until
bushing boot is fully seated into seal groove on that
end of sleeve (Fig. 35). Install other end bushing boot
into groove on that end of bushing sleeve.
(7) Verify both ends of bushing are seated in sleeve
groves (Fig. 36). When sleeve is seated properly into
bushing, sleeve/bushing can be held between fingers
and easily slid back and forth without bushing
unseating from sleeve groove.
ASSEMBLY - CALIPER PISTON AND SEAL
CAUTION: Dirt, oil, and solvents can damage cali-
per seals. Ensure assembly area is clean and dry.
NOTE: Always use new, clean Mopar DOT 3 Motor
Vehicle Brake Fluid when assembling brake caliper.
NOTE: Never use old piston seals or boots.
(1) Lubricate caliper pistons, piston seals and pis-
ton bores with clean, fresh brake fluid.
BRAKES 5 - 21
Advertisement
Table of Contents
