Table of Contents
Advertisement
CS
HUB / BEARING (Continued)
Fig. 2 Hub Nut And Lock
1 - HUB NUT
2 - NUT LOCK
3 - COTTER PIN
4 - SPRING WASHER
Fig. 3 Rear Wheel Speed Sensor Cable Routing
1 - WIRING HARNESS CONNECTOR
2 - SPARE TIRE MOUNTING SUPPORT
3 - WHEEL SPEED SENSOR CONNECTOR
4 - ROUTING CLIPS
5 - ROUTING CLIPS
6 - ROUTING BRACKET ON BRAKE SUPPORT
(9) Disconnect sensor cable from bracket on brake
support (Fig. 3).
(10) Completely loosen, but do not remove four
bolts fastening hub and bearing in place (Fig. 4).
Once loosened from threads in hub and bearing, push
bolts up against rear of hub and bearing to keep
brake support plate in place when hub and bearing is
removed.
(11) Pull hub and bearing off knuckle and half
shaft (if equipped with AWD), then thread wheel
speed sensor cable through hole in brake support
plate as it is removed with hub and bearing (Fig. 5).
Fig. 4 Hub And Bearing Mounting Bolts
1 - HUB AND BEARING
2 - MOUNTING BOLTS
3 - HALF SHAFT (IF EQUIPPED)
Fig. 5 Hub And Bearing Removal/Installation
1 - HUB AND BEARING
2 - HALF SHAFT (IF EQUIPPED)
3 - BRAKE SUPPORT PLATE
4 - WHEEL SPEED SENSOR CABLE
INSTALLATION
(1) Position hub and bearing bolts though rear of
knuckle and parking brake support just enough to
hold support in place as hub and bearing is installed.
(2) Install hub and bearing by first feeding end of
wheel speed sensor cable through hole in bottom of
parking brake support (Fig. 5). As this is being done,
if equipped with AWD, slide hub and bearing onto
REAR SUSPENSION 2 - 21
Advertisement
Table of Contents
