Table of Contents
Advertisement
8L - 32
LAMPS/LIGHTING - INTERIOR
READING LAMPS (Continued)
Fig. 11 FRONT READING LAMP LENS - REMOVAL
1 - POWER LIFTGATE, SUN ROOF CONTROLS (IF EQUIPPED)
2 - OVERHEAD CONSOLE
3 - FRONT READING LAMP LENS
4 - TRIM STICK (SPECIAL TOOL #C-4755)
5 - UNIVERSAL TRANSMITTER
REAR READING LAMPS - 2ND AND 3RD ROWS
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Open door.
(3) Using a trim stick (special tool #4755) or equiv-
alent, gently pry out from the side or bottom of the
lamp lens to remove (Fig. 12).
Fig. 12 REAR READING LAMP LENS - REMOVAL
1 - COAT HOOK
2 - REAR READING LAMP LENS
3 - TRIM STICK (SPECIAL TOOL #C-4755)
(4) Gently pry up on the edge of the lamp and pull
out of the overhead console to remove (Fig. 13).
Fig. 13 REAR READING LAMP - REMOVAL
INSTALLATION
FRONT READING LAMP
(1) Place lamp over retaining clips in overhead
console retaining clips and firmly snap into place.
(2) Place the front reading lamp lens over the
retaining pins making sure that they are lined up
and them firmly snap into place (Fig. 11).
(3) Connect the battery negative cable.
(4) Close hood.
(5) Verify vehicle and system operation.
(6) Close front door.
REAR READING LAMP - 2ND AND 3RD ROWS
(1) Place lamp over retaining clips in rear reading
lamp unit retaining clips and firmly snap into place
(Fig. 13).
(2) Place the rear reading lamp lens over the
retaining pins making sure that they are lined up
and them firmly snap into place (Fig. 12).
(3) Connect the battery negative cable.
(4) Close hood.
(5) Verify vehicle and system operation.
(6) Close front door.
VANITY LAMP
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Open door.
(3) Using a trim stick (special tool #C-4755) or
equivalent, gently pry out on vanity lamp lens and
remove from the vanity (Fig. 14).
(4) Gently pry up on the edge of the lamp and pull
out of the vanity unit to remove (Fig. 15).
CS
Advertisement
Table of Contents
