Table of Contents
Advertisement
CS
QUARTER GLASS INTEGRAL ANTENNA (Continued)
DIAGNOSIS AND TESTING - QUARTER GLASS
INTEGRAL ANTENNA
The antenna grid pattern is divided into two sepa-
rate patterns. Each terminal connects to a separate
grid pattern, one for AM and the other for FM.
For circuit descriptions and diagrams, refer to the
appropriate wiring information. The wiring informa-
tion includes wiring diagrams, proper wire and con-
nector repair procedures, details of wire harness
routing and retention, connector pin-out information
and location views for the various wire harness con-
nectors, splices and grounds. To detect breaks in the
integral antenna elements, the following procedure is
required:
(1) Disconnect the antenna module connector from
the antenna terminals on the glass.
(2) Using an ohmmeter, place a lead on one of the
terminals and check each end of the grid pattern con-
nected to this terminal for continuity. If continuity is
not present, move one lead through the grid in pro-
gression starting at the terminal with the other lead
on the terminal until continuity is lost. Repeat pro-
cedure for the other terminal. A break in the antenna
grid can be repaired using a Mopar Rear Window
Defogger Repair Kit or equivalent.
RADIO
DESCRIPTION
Available factory-installed radio receivers for this
model include:
• AM/FM/CD with CD/DVD changer control (RAH
sales code)
• AM/FM/cassette/CD/equalizer
changer control feature (RBP sales code)
OPERATION
The radio receiver operates on ignition switched
battery current that is available only when the igni-
tion switch is in the On or Accessory/Accessory Delay
positions.
REMOVAL
(1) Disconnect and isolate the battery negative
cable.
(2) Remove instrument panel center bezel (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - REMOVAL).
(3) Remove radio mounting screws.
(4) Pull radio rearward to gain access to the back
of radio (Fig. 7).
CAUTION: Pulling the antenna cable straight out of
the radio without pulling on the locking antenna
connector could damage the cable or radio.
(5) Disconnect the antenna cable by pulling the
locking antenna connector away from the radio (Fig.
8).
with
CD/DVD
1 - RADIO
2 - LOCKING ANTENNA CONNECTOR
3 - INSTRUMENT PANEL ANTENNA CABLE
(6) Disconnect the wire harness connectors from
the back of the radio.
INSTALLATION
(1) Connect wire harness connector and antenna
cable to back of radio.
(2) Position radio into instrument panel.
(3) Install mounting screws. Tighten to 2 N·m (22
in. lbs.).
(4) Install instrument panel center bezel (Refer to
23 - BODY/INSTRUMENT PANEL/INSTRUMENT
PANEL CENTER BEZEL - INSTALLATION).
(5) Connect battery negative cable.
AUDIO/VIDEO 8A - 9
Fig. 7 RADIO
Fig. 8 ANTENNA TO RADIO
Advertisement
Table of Contents
