Table of Contents
Advertisement
CS
LICENSE PLATE LAMP
REMOVAL
(1) Open hood, disconnect and isolate the battery
negative cable.
(2) Using a trim stick (special tool #C-4755) or
equivalent, gently pry in and then down on the left
side of the lamp cover (Fig. 30) (shown reversed) and
(Fig. 31).
Fig. 30 LICENSE PLATE LAMP COVER LATCH
1 - LICENSE PLATE LAMP COVER
2 - PLACE TOOL HERE TO PRY
Fig. 31 LICENSE PLATE LAMP COVER - REMOVAL
1 - INSERT HERE TO PRY OFF LICENSE PLATE LAMP COVER
(3) Pull license lamp out of liftgate light bar and
remove.
LAMPS/LIGHTING - EXTERIOR 8L - 25
NOTE: If the license plate lamp unit, located within
the liftgate light bar needs replacing, (Refer to 23 -
BODY/LIFTGATE/LIFTGATE
REMOVAL).
INSTALLATION
(1) Align lamp with slot in socket and firmly push
straight in.
(2) Position the lamp cover over retaining slots
and firmly snap into place (Fig. 31).
(3) Connect the battery negative cable.
(4) Verify vehicle and system operation.
(5) Close hood.
REAR SIDE MARKER LAMP
REMOVAL
(1) Remove the tail lamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - REMOVAL).
(2) Twist counterclockwise and pull out lamp from
tail lamp unit.
(3) Pull lamp straight out of lamp socket.
INSTALLATION
(1) Push lamp straight into lamp socket.
(2) Place lamp into tail lamp unit and then twist
clockwise until lamp stops (about 1/4 turn).
(3) Install the tail lamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
TAIL LAMP
REMOVAL
(1) Remove the tail lamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - REMOVAL).
(2) Twist counterclockwise and pull out lamp from
tail lamp unit.
(3) Pull lamp straight out of lamp socket.
INSTALLATION
(1) Push lamp straight into lamp socket.
(2) Place lamp into tail lamp unit and then twist
clockwise until lamp stops (about 1/4 turn).
(3) Install the tail lamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
LIGHT
BAR
-
-
EXTERIOR/TAIL
-
EXTERIOR/TAIL
-
EXTERIOR/TAIL
-
EXTERIOR/TAIL
Advertisement
Table of Contents
