Table of Contents
Advertisement
Symptom:
DRIVER RECLINE SWITCH STUCK - DDM
When Monitored and Set Condition:
DRIVER RECLINE SWITCH STUCK - DDM
When Monitored: Continuously.
Set Condition: If the switch is held in the on position for over 30 seconds, this code will
set.
DTC PRESENT
DRIVER POWER SEAT SWITCH
DRIVER SEAT RECLINER/LUMBAR OUT SWITCH MUX
DRIVER DOOR MODULE
TEST
1
Check the seat switches mechanical operation and also check for a possible obstruc-
tion. Correct if necessary.
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run.
Operate the Seat Switch in all positions several times.
With the DRBIII , read DTCs.
Does the DRBIII display DRIVER RECLINE SWITCH STUCK?
Yes → Go To 2
→ The condition that caused this code to set is not present at this
No
2
Disconnect the Driver Power Seat Switch connector.
Turn the ignition on.
With the DRBIII , erase DTCs.
Cycle the ignition switch from Off to Run and wait 30 seconds.
With the DRBIII , read DTCs.
Does the DRBIII display DRIVER RECLINE SWITCH STUCK?
Yes → Go To 3
→ Replace the Driver Power Seat Switch.
No
POSSIBLE CAUSES
ACTION
time. Operate the switch several times to ensure it does not stick.
If the switch ever sticks, replace it.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1.
Perform POWER SEAT SYSTEM VERIFICATION TEST - VER 1.
861
POWER SEATS
APPLICABILITY
All
All
Advertisement
Table of Contents
