Table of Contents
Advertisement
CS
ROTOR (Continued)
SPECIFICATIONS
BRAKE ROTOR
NOTE: When refacing a rotor, the required TIR (Total
Indicator Reading) and thickness variation limits MUST
BE MAINTAINED. Extreme care in the operation of
rotor turning (machining) equipment is required.
Brake Rotor
Front
Rear
* TIR Total Indicator Reading (Measured On Vehicle)
PARKING BRAKE
STANDARD PROCEDURE
STANDARD PROCEDURE - AUTOMATIC
ADJUSTER LOCKING OUT
(1) Place an assistant inside passenger compart-
ment with pin (pin punch or drill bit) to be used in
Step 5.
(2) Place parking brake lever in "released" position.
(3) Raise and support vehicle. (Refer to LUBRICA-
TION & MAINTENANCE/HOISTING - STANDARD
PROCEDURE)
(4) Grasp exposed section of parking brake cable
at cable connector (front-to-right rear cable) (Fig.
70)and pull outward on front cable. Pull on cable
until it stops and hold it in this position.
(5) Have assistant inside passenger compartment
insert pin punch (locking pin or drill bit) into hole in
lever and foot pedal, past tang on adjuster mecha-
nism, and through hole in backing plate of lever (Fig.
71) (Fig. 72). Hold pin in place. This pin will lock
automatic adjuster spring out once technician under
vehicle releases grasp on cables and will allow safe
removal of cables and lever as necessary.
WARNING: DO NOT RELEASE THE AUTOMATIC
ADJUSTER LOCKOUT DEVICE UNLESS THE PARK-
ING BRAKE CABLES AND EQUALIZER ARE CON-
NECTED. KEEP HANDS OUT OF AUTOMATIC
ADJUSTER SECTOR AND PAWL AREA. FAILURE TO
OBSERVE CAUTION IN HANDLING THIS MECHA-
NISM COULD LEAD TO SERIOUS INJURY.
LIMITS/SPECIFICATIONS
Rotor Thickness
27.87-28.13 mm
1.097-1.107 in.
13.87-14.13 mm
0.546-0.556 in.
Minimum Rotor
Thickness
26.5 mm
1.040 in
12.5 mm
0.492 in.
Fig. 70 Cable Routing And Connections
1 - REAR DRIVELINE MODULE (AWD MODELS ONLY)
2 - LEFT REAR CABLE END BUTTON
3 - RIGHT REAR CABLE
4 - RIGHT REAR CABLE END BUTTON
5 - CONNECTOR ON END OF FRONT CABLE
6 - SCREW
7 - FRONT CABLE ROUTING CLAMP
8 - FRONT CABLE
9 - LEFT FRAME RAIL
10 - EQUALIZER
11 - LEFT REAR CABLE
BRAKES 5 - 39
Rotor
Thickness
Rotor Runout *
Variation
0.009 mm
0.035 mm
0.0004 in.
0.0014 in.
0.009 mm
0.14 mm
0.0004 in.
0.0055 in.
Advertisement
Table of Contents
