Table of Contents
Advertisement
CS
HALF SHAFT - REAR (Continued)
Fig. 1 Cotter Pin, Nut Lock, And Spring Washer
1 - HUB NUT
2 - NUT LOCK
3 - COTTER PIN
4 - SPRING WASHER
(8) Lower exhaust system at least 254 mm (10 in.).
Support system with suitable wire or rope.
(9) Index propeller shaft and rear driveline module
flanges using paint mark, chalk, etc. for installation
reference.
(10) Remove three (3) propeller shaft-to-driveline
module bolts. Do not attempt to disconnect shaft
from module, as it will be disconnected upon lower-
ing driveline module.
(11) Support driveline module with transmission
jack (or equivalent) (Fig. 2).
Fig. 2 Support Module with Jack
1 - DRIVELINE MODULE
2 - TRANSMISSION JACK
(12) Using suitable screwdriver, partially dislodge
halfshaft (side being removed) from differential.
Install Tool 9099 to protect seal upon disassembly
(Fig. 3).
Fig. 3 Install Seal Protector
1 - HALFSHAFT
2 - SEAL PROTECTOR
(13) Remove three (3) rear driveline module-to-
crossmember bolts (Fig. 4) (Fig. 5).
Fig. 4 Module Mounting Bolt
1 - BOLT
2 - DRIVELINE MODULE
(14) Lower driveline module assembly just enough
to facilitate removal of shaft from differential. Make
sure Tool 9099 engages seal.
(15) Disconnect propeller shaft from driveline mod-
ule and secure to exhaust system (Fig. 6).
HALF SHAFT - REAR 3 - 15
Advertisement
Table of Contents
