Table of Contents
Advertisement
Symptom:
DRIVER MIRROR COMMON OUTPUT SHORT TO BATTERY - DDM
When Monitored and Set Condition:
DRIVER MIRROR COMMON OUTPUT SHORT TO BATTERY - DDM
When Monitored: Whenever mirror is idle.
Set Condition: Driver circuit is shorted to battery.
DTC PRESENT
POWER MIRROR
DRIVER MIRROR COMMON DRIVER SHORTED TO VOLTAGE
DRIVER DOOR MODULE
TEST
1
With the DRBIII , erase DTCs.
Cycle the ignition switch Off then back On.
With the DRBIII , read DTCs.
Did the same DTC return?
Yes → Go To 2
No
2
Turn the ignition off.
Disconnect the power mirror connector.
Using the DRBIII , erase DTC's.
Turn the ignition on.
Cycle the ignition switch Off then back On.
With the DRBIII , read DTC's.
Did the same DTC return?
Yes → Go To 3
No
POSSIBLE CAUSES
ACTION
→ The conditions required to set the code are currently not present.
Using the wiring diagram/schematic as a guide, inspect the
wiring and connectors.
Perform BODY VERIFICATION TEST - VER 1.
→ Inspect the power mirror harness for a short, if OK replace the
mirror.
Perform BODY VERIFICATION TEST - VER 1.
777
POWER MIRROR
APPLICABILITY
All
All
Advertisement
Table of Contents
