Table of Contents
Advertisement
POWER MIRROR
DRIVER MIRROR VERTICAL SENSOR CIRCUIT SHORT - DDM —
Continued
TEST
3
Turn the ignition off.
Disconnect the Driver Door Module C3 connector.
Disconnect the Driver Power Mirror connector.
Measure the resistance of the Driver Mirror Vertical Position Signal circuit to ground
at the Driver Power Mirror harness side connector.
Is the resistance below 1000.0 ohms?
Yes → Repair the Driver Mirror Vertical Position Signal wire for a short
→ Replace the Driver Door Module.
No
ACTION
to ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
798
APPLICABILITY
All
Advertisement
Table of Contents
