Table of Contents
Advertisement
POWER MIRROR
Symptom:
PASSENGER MIRROR VERTICAL SENSOR CIRCUIT OPEN - PDM
When Monitored and Set Condition:
PASSENGER MIRROR VERTICAL SENSOR CIRCUIT OPEN - PDM
When Monitored: Continuously.
Set Condition: If the voltage on the Passenger Mirror Vertical Position Signal circuit is
above 4.1 volts for over 10 seconds, this code will set.
PASSENGER MIRROR SENSOR GROUND WIRE OPEN
PASSENGER MIRROR VERTICAL POSITION WIRE SHORTED TO VOLTAGE
STORED DIAGNOSTIC TROUBLE CODE
PASSENGER MIRROR VERTICAL POSITION SIGNAL OPEN
PASSENGER POWER MIRROR
PASSENGER DOOR MODULE - SENSOR GROUND
PASSENGER DOOR MODULE - VERTICAL POSITION SIGNAL
TEST
1
With the DRBIII , erase the DTC from the Passenger Door Module.
Operate the passenger's power mirror and memory system.
Turn the ignition switch to the Off position then start the engine and let run for one
minute.
With the DRBlll check for the same DTC to return in the PDM.
Did the same DTC return?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2
Turn the ignition off.
Disconnect the Passenger Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Driver Mirror Vertical Position Signal circuit in the
Passenger Power Mirror harness connector.
Is the voltage between 4.5 and 5.5 volts?
Yes → Go To 3
→ Go To 6
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
816
APPLICABILITY
All
All
Advertisement
Table of Contents
