Table of Contents
Advertisement
PINCH SENSOR CIRCUIT OPEN —
TEST
7
Remove the left rear trim panel.
Remove the liftgate trim panel.
Disconnect the Power Liftgate Module C2 connector.
Disconnect the Liftgate Left Pinch Sensor connector.
Measure the resistance of the Pinch Sensor Signal circuit between the PLG C2
connector and the Liftgate Left Pinch Sensor connector.
Is the resistance below 5.0 ohms?
Yes → Test Complete.
No
ACTION
→ Repair the Pinch Sensor Signal wire for an open.
Perform BODY VERIFICATION TEST - VER 1.
POWER DOORS - LIFTGATE
Continued
771
APPLICABILITY
All
Advertisement
Table of Contents
