Table of Contents
Advertisement
PASSENGER MIRROR VERTICAL SENSOR CIRCUIT SHORT - PDM —
Continued
TEST
3
Turn the ignition off.
Disconnect the Passenger Door Module C3 connector.
Disconnect the Passenger Power Mirror connector.
Measure the resistance of the Passenger Mirror Vertical Position Signal circuit to
ground at the Passenger Power Mirror harness side connector.
Is the resistance below 1000.0 ohms?
Yes → Repair the Passenger Mirror Vertical Position Signal wire for a
→ Replace the Passenger Door Module.
No
ACTION
short to ground.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
819
POWER MIRROR
APPLICABILITY
All
Advertisement
Table of Contents
