Table of Contents
Advertisement
CS
PARKING BRAKE SHOES (Continued)
Fig. 84 Parking Brake Shoes
1 - ACTUATOR
2 - SUPPORT
3 - ADJUSTER SPRING
4 - RETURN SPRING
5 - CALIPER ADAPTER
6 - SHOES
7 - HOLD-DOWN CLIPS AND PINS
8 - ADJUSTER
(8) Remove upper brake shoe hold-down clip and
pin (Fig. 84).
(9) Remove lower brake shoe hold-down clip and
pin (Fig. 84).
(10) Remove upper and lower shoes with return
spring from shoe actuator.
(11) Remove return spring from shoes.
INSTALLATION
NOTE: The following procedure may be used to
install shoes on either side of the vehicle.
(1) Install return spring between upper and lower
shoes.
NOTE: Before installing shoes on actuator, make
sure actuator hooked to rear cable is positioned
with word "UP" facing outward (Fig. 83).
(2) Install upper and lower shoes with return
spring on shoe actuator located on parking brake
cable (Fig. 84).
(3) Install lower brake shoe hold-down pin through
rear of support and lower shoe, then install hold-
down clip (Fig. 84).
(4) Install
upper
through rear of support and upper shoe, then install
hold-down clip (Fig. 84).
(5) Install shoe adjuster (Fig. 84). Place end of
adjuster with star wheel upward.
(6) Install parking brake shoe adjuster spring (Fig.
84).
brake
shoe
hold-down
(7) Install bolt securing parking brake cable to
knuckle (Fig. 80). Tighten bolt to 28 N·m (21 ft. lbs.)
torque.
(8) Using Brake Shoe Gauge, Special Tool C-3919,
or equivalent, measure inside diameter of parking
brake drum portion of rotor (Fig. 85).
Fig. 85 Measuring Parking Brake Drum Diameter
(9) Place Gauge over parking brake shoes at wid-
est point (Fig. 86).
Fig. 86 Measuring Parking Brake Shoes
1 - BRAKE SHOE GAUGE
2 - ADJUSTER STAR WHEEL
(10) Using adjuster star wheel (Fig. 86), adjust
parking brake shoes until linings on both park brake
shoes just touch jaws on gauge. This will give a good
preliminary adjustment of parking brake shoes,
pin
before a final adjustment is made at end of this pro-
cedure.
(11) Install hub and bearing with wheel speed sen-
sor as well as all components necessary to access it.
(Refer to 2 - SUSPENSION/REAR/HUB / BEARING -
INSTALLATION)
(12) Lower vehicle.
BRAKES 5 - 47
Advertisement
Table of Contents
