Table of Contents
Advertisement
8L - 24
LAMPS/LIGHTING - EXTERIOR
LEFT MULTI-FUNCTION SWITCH (Continued)
1 - RIGHT MULTI-FUNCTION SWITCH CONNECTOR
2 - CLOCK SPRING AIRBAG CONNECTORS
3 - MULTI-FUNCTION SWITCH ASSEMBLY W/CLOCK SPRING
in the back of the housing. The oblong hole in the
hub of the cam should now be at the top, and the
locating tab in the hub of the cam should be at the
bottom (Fig. 29).
(2) Position the multi-function switch housing onto
the top of the steering column. The locating tab in
the hub of the turn signal cancel cam must be
engaged with the alignment groove in the bottom of
the upper steering column shaft.
(3) Install and tighten the screw that secures the
multi-function switch housing to the top of the col-
umn housing (Fig. 26). Torque screw to 1.9 N·m (17
in. lbs.).
(4) Install the right multi-function switch onto the
multi-function switch housing. (Refer to 8 - ELEC-
TRICAL/WIPERS/WASHERS/RIGHT MULTI-FUNC-
TION SWITCH - INSTALLATION).
(5) Install the left multi-function switch onto the
multi-function switch housing (refer to above proce-
dure).
(6) Install the clock spring onto the multi-function
switch housing. (Refer to 8 - ELECTRICAL/RE-
STRAINTS/CLOCK SPRING - INSTALLATION).
(7) Connect the battery negative cable.
(8) Verify vehicle and system operation.
Fig. 28 MULTI-FUNCTION SWITCH - REMOVE/INSTALL
4 - CLOCK SPRING RADIO, SPEED CONTROL, AND HORN
CONNECTOR
5 - LEFT MULTI-FUNCTION SWITCH CONNECTOR
6 - MULTI-FUNCTION SWITCH MOUNTING HOUSING RETAINING
SCREW
Fig. 29 TURN SIGNAL CANCELLING CAM
ALIGNMENT
1 - ALIGNMENT HOLE
2 - MULTI-FUNCTION SWITCH MOUNTING HOUSING
3 - ALIGNMENT HOLE
4 - TURN SIGNAL CANCEL CAM
5 - LOCATING TAB
6 - WASHER
7 - TURN SIGNAL SWITCH CANCEL ACTUATOR
CS
Advertisement
Table of Contents
