Table of Contents
Advertisement
POWER MIRROR
Symptom:
PASSENGER MIRROR VERTICAL SENSOR CIRCUIT SHORT - PDM
When Monitored and Set Condition:
PASSENGER MIRROR VERTICAL SENSOR CIRCUIT SHORT - PDM
When Monitored: Continuously.
Set Condition: If the voltage on the Passenger Vertical Position Signal circuit is below 0.1
volt for over 10 seconds, this code will set.
PDM - VERTICAL POSITION LOW
STORED DIAGNOSTIC TROUBLE CODE
PASSENGER MIRROR VERTICAL POSITION SIGNAL WIRE SHORT TO GROUND
PASSENGER POWER MIRROR
TEST
1
With the DRBIII , erase the DTC from Passenger Door Module.
Operate the passenger's power mirror and memory system.
Turn the ignition switch to the Off position then start the engine and let run for one
minute.
With the DRBlll check for the same DTC to return in the PDM.
Did the same DTC return?
Yes → Go To 2
→ Using the wiring diagram/schematic as a guide, inspect the
No
2
Turn the ignition off.
Disconnect the Passenger Power Mirror connector.
Turn the ignition on.
Measure the voltage of the Passenger Mirror Vertical Position Signal circuit in the
Passenger Power Mirror harness connector.
Is the voltage between 4.5 and 5.5 volts?
Yes → Replace the Passenger Power Mirror.
→ Go To 3
No
POSSIBLE CAUSES
ACTION
wiring and connectors for an intermittent condition.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
818
APPLICABILITY
All
All
Advertisement
Table of Contents
