P3-Xx Communication Parameters - Delta ASDA-B2-F Series User Manual

Parameters

P3-xx Communication Parameters

P3-00●
Operational
7
Interface:
Default: 01
Format: HEX
Settings:
The communication address setting is divided into Y and X (hexadecimal):
When using RS-232 to communicate, one servo drive can only set one address. Duplicate address
setting will cause abnormal communication.
This address represents the absolute address of the servo drive in the communication network
which is applicable to RS-232 and DMCNET bus.
When the communication address setting of MODBUS is set to 0xFF, the servo drive will
automatically reply and receive data regardless of the address. However, P3-00 cannot be set to
0xFF.
P3-01
Operational
Interface:
Default: 3203
Format: HEX
Settings:
The setting of transmission speed is divided into Z, Y and X (hexadecimal):


Note:
If this parameter is set via DMCNET, only Z can be set and the others remain.
P3-02
Operational
Interface:
Default: 6
Format: HEX
Settings:
The definition of the setting value is as the followings:
0: 7, N, 2(MODBUS, ASCII)
3: 8, N, 2(MODBUS, ASCII)
7-50
ADR Address Setting
Panel / Software Communication
Unit: -
- 0
－
Range
BRT Transmission Speed
Panel / Software Communication
Unit: Bps
-
Communication Port
Range
Definition of setting value X
0: 4800 1: 9600
3: 38400 4: 57600
Definition of setting value Z
0: 125 Kbit/s 1: 250 Kbit/s
3: 750 Kbit/s 4: 1.0 Mbit/s
PTL Communication Protocol
Panel / Software Communication
Unit: Bps
Related
Section:
Control
Mode:
Range: 0x01 ~ 0x7F
Data Size: 16-bit
0 Y
－
0 ~ 7
Related
Section:
Control
Mode:
Range: 0x000 ~ 0x3405
Data Size: 16-bit
0 Z Y
－ －
DMCNET
0 0 ~ 4 0
2: 19200
5: 115200
2: 500 Kbit/s
-
Related
Section:
Control
Mode:
Range: 0 ~ 8
Data Size: 16-bit
1: 7, E, 1(MODBUS, ASCII)
4: 8, E, 1(MODBUS, ASCII)
Address: 0300H
0301H
-
ALL
X
0 ~ F
Address: 0302H
0303H
-
ALL
X
RS-232
0 ~ 5
Address: 0304H
0305H
-
ALL
2: 7, O, 1(MODBUS, ASCII)
5: 8, O, 1(MODBUS, ASCII)
ASDA-B2-F
September, 2015