Measurement (M5); Signals From Nc (Db10); Signals From Axis/Spindle (Db31 - Siemens SINUMERIK Series Function Manual

18.7

Measurement (M5)

18.7.1

Signals from NC (DB10)

DB10
DBX107.0 and
DBX107.1 Probe actuated
Edge evaluation: No
Signal state 1 or Probe 1 or 2 is actuated.
edge change 0 → 1
Signal state 0 or Probe 1 or 2 is not actuated.
edge change 1 → 0
References Equipment Manual NCU
18.7.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX62.3 Measuring status
Edge evaluation: No
Signal state 1 or The "Measuring" function is active.
edge change 0 → 1
This signal is used during measuring and displays the current measuring status of the axis.
Signal state 0 or The "Measuring" function is not active.
edge change 1 → 0
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Signal(s) updated: Cyclic
Signal(s) updated: Cyclic
Z2: NC/PLC interface signals
18.7 Measurement (M5)
887