Siemens SINUMERIK Series Function Manual page 165

NC/PLC interface signal
DB11 DBX0.5 (mode group
stop)
DB11 DBX0.6 (mode group
stop, axes plus spindle)
DB21, ... DBX7.3 (NC Stop)
DB21, ... DBX7.4 (NC stop,
axes plus spindle)
DB21, ... DBX6.0 (feedrate
disable)
DB21, ... DBB4 (feedrate
override)
DB31, ... DBX4.5 (rapid
traverse override)
DB21, ... DBB5 (rapid
traverse override)
DB31, ... DBX4.5 (rapid
traverse override)
DB21, ... DBX12/16/20.3
(geometry axis 1/2/3:
Feedrate stop)
NC/PLC interface signal
DB31, ... DBB0 (axial
feedrate override)
DB31, ... DBB19 (spindle
override)
DB31, ... DBX4.3 (feedrate
stop / spindle stop)
DB31, ... DBX2.3 (clamping
in progress)
DB31, ... DBX2.1 (control
system enable)
DB31, ... DBX21.7 (pulse
enable)
Note
Removal of the "Controller enable" and "Pulse enable" during traversing results in a rapid
stop of the axis and a reset alarm.
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Scope
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axes
Geometry axes
Geometry axis
Scope
Machine axis, not spindle
Spindle
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axis / machine
axis
Geometry axis / machine
axis
H1: Manual and handwheel travel
MD20624 $MC_HANDWH_CHAN_STOP_COND
Bit == 0
Interruption until NC start
Interruption until NC start
Interruption until NC start
Interruption until NC start
Interruption
Override == 0: Interruption if
rapid traverse override is not
active
Rapid traverse override == 0:
Interruption if rapid traverse
override is active
Interruption
MD32084 $MC_HANDWH_CHAN_STOP_COND
Bit == 0
Override == 0: Interruption
Override == 0: Interruption
Interruption
No effect
Interruption
Interruption
3.4 Handwheel travel in JOG
Bit == 1
Abort
Abort
Abort
Abort
Abort
Override == 0: Abort if rapid
traverse override is not
active
Rapid traverse override == 0:
Abort if rapid traverse
override is active
Abort
Bit == 1
Override == 0: Abort
Override == 0: Abort
Abort
Abort
Abort
Abort
165