Siemens SINUMERIK Series Function Manual page 102

B3: Distributed systems - 840D sl only
2.2 NCU link
Axis container name
The following program commands can be addressed via the axis container name (<axis
container>):
● Program commands:
The following names are possible:
CT<container number>
<container name>
<axis name>
Implicit wait
There is an implicit wait for the completion of a requested axis container rotation if one of the
following events has occurred:
● Part program language commands which will cause a container axis assigned to this axis
●
● The next
Note
Even an
block change in addressing according to incremental dimension even though an absolute
dimension has been set globally).
102
–
AXCTSWE(<axis container>)
–
AXCTSWED(<axis container>)
–
AXCTSWEC(<axis container>)
:
:
:
container in this channel to move
GET(<channel axis name>)
AXCTSWE(<axis container>)
will result in a wait including synchronization where necessary (block-by-
IC(0)
The number of the axis container is attached to the CT letter
combination.
Example:
CT3
Individual name of the axis container set using
MD12750 $MN_AXCT_NAME_TAB
Example:
A_CONT3
Axis name of a container axis which is known in the channel
involved.
on a corresponding container axis
for this axis container
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions