Telegram Selection; Measurement Results - Siemens SINUMERIK Series Function Manual

7.4.2

Telegram selection

Telegram selection for the axial measurement with MEAC
By default, the axial measurement is implemented with PROFIBUS telegram 391.
PROFIBUS telegram 395 is used for measuring with several measured values per trigger
event and the position control cycle.
The telegram selection is made from the STEP 7 HW Config, in the "DP Slave Properties" >
"Configuration" dialog.
The following settings are also required:
● Drive parameters:
● PROFIBUS connection:
7.4.3

Measurement results

Read measurement results of MEASA, MEAWA
The results of the measurement commands are stored in system data of the NCK and can
be read via system variables in the part program.
● System variable $AC_MEA[No]
● System variable $AA_MM1[axis] to $AA_MM4[axis]
● System variable $AA_MW1[axis] to $AA_MW4[axis]
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
CU: p0922 = 395; setting for the telegram selection
CU: p0684 = 16; setting of the measuring procedure
CU: p0680; configuration of the central probe terminal
MD13211 $MN_MEAS_CENTRAL_SOURCE = 2 (telegram integration without
handshake)
Query measurement job status signal.
[No] stands for probe (1 or 2)
The variable is deleted at the beginning of a measurement. The variable is set as soon as
the probe fulfills the activation criterion (rising or falling edge). Execution of the
measurement job can thus be checked in the part program.
Access to the measured value of the trigger signal in the machine coordinate system.
Read in part program and in synchronized actions.
[Axis] stands for the name of the measurement axis (X, Y, ...).
Access to the measured value of the trigger signal in the workpiece coordinate system.
Read in part program and in synchronized actions.
[Axis] stands for the name of the measurement axis (X, Y, ...).
M5: Measurement
7.4 Axial measurement
449