Siemens SINUMERIK Series Function Manual page 899

DB31, ...
DBX28.3
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
DB31, ...
DBX28.4
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Corresponding to ....
DB31, ...
DBX28.5
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Corresponding to ....
DB31, ...
DBX28.6
Edge evaluation: No
Signal state 1 or edge
change 0 → 1
Signal state 0 or edge
change 1 → 0
Corresponding to ....
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Set reversal point
Signal(s) updated: Cyclic
Reversal point 2
Reversal point 1
Alter reversal point
Signal(s) updated: Cyclic
The selected reversal point can be altered by manual traverse.
In conjunction with DB31, ...DBX28.0:
The position at which axis is braked after external oscillation reversal must be accepted as
new reversal point.
The selected reversal point cannot be altered by manual traverse.
In conjunction with DB31, ...DBX28.0:
No change to reversal point
DBX28.3
Stop at next reversal point
Signal(s) updated: Cyclic
The oscillation movement is interrupted at the next reversal point.
The oscillation movement continues after the next reversal point.
DBX28.6, DBX28.7
Stop along braking ramp
Signal(s) updated: Cyclic
The axis is decelerated along a ramp, the oscillation movement is interrupted.
The oscillation movement continues without interruption.
DBX28.5, DBX28.7
Z2: NC/PLC interface signals
18.11 Oscillation (P5)
899