Output Of Cam Signals; Activating - Siemens SINUMERIK Series Function Manual

N3: Software cams, position switching cycles - only 840D sl

8.3 Output of cam signals

Lead or delay time in setting data
The second lead or delay time is entered into the following general setting data:
• SD41520 SW_CAM_MINUS_TIME_TAB_1[n]
• SD41521 SW_CAM_PLUS_TIME_TAB_1[n]
• SD41522 SW_CAM_MINUS_TIME_TAB_2[n]
• SD41523 SW_CAM_PLUS_TIME_TAB_2[n]
• SD41524 SW_CAM_MINUS_TIME_TAB_3[n]
• SD41525 SW_CAM_PLUS_TIME_TAB_3[n]
• SD41526 SW_CAM_MINUS_TIME_TAB_4[n]
• SD41527 SW_CAM_PLUS_TIME_TAB_4[n]
Delay times which may change during machining must, for example, be entered in the
setting data.
8.3 Output of cam signals
8.3.1

Activating

The status of the cam (cam signals) can be output to the PLC as well as to the NCK I/Os.
Activation of cam signal output
The output of cam signals of an axis is activated via the NC/PLC interface signal:
DB31, ... DBX2.0 (cam activation)
Check-back signal to PLC
The successful activation of all cams of an axis is signaled back to the PLC using the
following NC/PLC interface signal:
DB31, ... DBX62.0 (cams active)
Note
The activation can be linked with other conditions by the PLC user (e.g. axis referenced,
reset active).
546
(lead or delay time at the minus
cams 1 – 8)
(lead or delay time at the plus
cams 1 – 8)
(lead or delay time at the minus
cams 9 – 16)
(lead or delay time at the plus
cams 9 – 16)
(lead or delay time at the minus
cams 17 – 24)
Lead or delay time on plus cams
17 - 24
(lead or delay time at the minus
cams 25 – 32)
(lead or delay time at the plus
cams 25 – 32)
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
Extended Functions