Siemens SINUMERIK Series Function Manual page 805

Definition of additional parameters $TC_DPC1...10
For user-specific cutting edge data, additional parameters $TC_DPC1 to 10 can be set up
independent of the tool type using the following general machine data:
MD18096 $MN_MM_NUM_CC_TOA_PARAM
Data loss
Changes to MD18096 take effect after power on and will lead to initialization of the
memory.
A data backup must be created beforehand.
No grinding wheel offset changeover
Automatic changeover between grinding wheel offset left and right does not take place
during contour grinding.
A changeover must be programmed.
Tool types for grinding tools
The structure of tool types for grinding tools is as follows:
Figure 17-2
Note
MD20350 $MC_TOOL_GRIND_AUTO_TMON
Through this channel-specific machine data it can be determined, whether for grinding tools
with monitoring (i.e. uneven tool types) the monitoring is already active or not when this tool
is selected.
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
CAUTION
CAUTION
Structure of tool type for grinding tools
W4: Grinding-specific tool offset and tool monitoring
17.1 Tool offset for grinding operations
805