Data Lists; Machine Data; General Machine Data - Siemens SINUMERIK Series Function Manual

Transverse axes
If a geometry axis is defined as transverse axis:
MD20100 $MC_DIAMETER_AX_DEF (geometry axes with transverse axis function)
and radius programming has been selected, when traversing in JOG, the following features
should be carefully observed:
● Continuous travel:
● Incremental travel:
● Traversing with the handwheel:
References:
Function Manual Basic Functions; Transverse Axes (P1)
3.12

Data lists

3.12.1

Machine data

3.12.1.1

General machine data

Number Identifier: $MN_
10000 AXCONF_MACHAX_NAME_TAB[n]
10720 OPERATING_MODE_DEFAULT
10721 OPERATING_MODE_EXTENDED
10735 JOG_MODE_MASK
11300 JOG_INC_MODE_LEVELTRIGGRD
11310 HANDWH_REVERSE
11320 HANDWH_IMP_PER_LATCH[n]
11324 HANDWH_VDI_REPRESENTATION
11330 JOG_INCR_SIZE_TAB[n]
11340 ENC_HANDWHEEL_SEGMENT_NR
11342 ENC_HANDWHEEL_MODULE_NR
11344 ENC_HANDWHEEL_INPUT_NR
11346 HANDWH_TRUE_DISTANCE
11350 HANDWHEEL_SEGMENT[n]
Extended Functions
Function Manual, 03/2013, 6FC5397-1BP40-3BA1
There are no differences when a transverse axis is traversed continuously.
Only half the distance of the selected increment size is traversed. For example, with
INC10 the axis only traverses 5 increments when the traversing key is pressed.
As for incremental travel, with the handwheel only half the distance is traversed per
handwheel pulse.
Description
Machine axis name
Setting of the operating mode after Power On
Extended setting of the operating mode after Power On
Settings for JOG mode
INC and REF in inching mode
Defines movement in the opposite direction
Handwheel pulses per locking position
Coding of the handwheel number (NCK/PLC interface)
Increment size for INC/handwheel
Third handwheel: Bus segment
Third handwheel: Logical drive number
Third handwheel: Encoder interface
Handwheel path or velocity specification
Handwheel segment
H1: Manual and handwheel travel
3.12 Data lists
215