Advertisement
OUT Mail (continued)
• If you send mail to a wrong address, a warning
sound is emitted and the message "Invalid
address" appears.
• If you send mail when the other party's number of
mail stored at the i-mode center is 50, a warning
sound is emitted and the message "Network server
full" appears.
• If the line equipment at the i-mode center is crowded,
a warning sound is emitted and the message
"Transmission incomplete i-mode center is busy"
appears. Try to send again after a while.
• If multiple errors have occurred in the
transmission of mail to two or more addresses at
the same time
latest error is displayed.
• When [add. book block]
you cannot select [From add. book] in step 3.
• If you receive mail when creating mail, then the
following procedures apply.
•
To return to the create mail process press
(
ｒｅｔｕｒｎ
) or [clear].
•
To view IN Mail press
the mail.
not be saved)
•
If you press
cancel editing process" appears. To quit the
mail creation process select "Cancel and End"
then press
mail, select [Continue Edit] then press
(
).
ｃａｎｃｅｌ
• When the mail function is disabled
cannot send mail.
• One-byte Katakana or E-MOJI may not displayed
correctly on the screen of the receiver. Do not use
one-byte Katakana or E-MOJI when sending mail
to mobile phones other than i-mode phones.
• The other party may not be able to properly
display the characters received depending on the
reception quality.
Hint
• If the mailing destination is an i-mode phone, the
address will be sent only in the part before @.
• If you OUT Mail when 20 OUT Mail are already
saved, the oldest is overwritten with the a new one.
But locked OUT Mail is not overwritten.
• If there arrives incoming mail or message while
sending mail, it is temporarily terminated and it is
resumed after the reception is completed.
• When an address is a phone number, you can
send as short mail.
• You can save created mail if one of [To:],
[Subject:] or [Text] is filled.
270
s
, the message for the
P.295
s
is turned [ON],
P.100
(
) to select
ｃａｎｃｅｌ
s
(the mail being created will
P.264
[power] the message "Okay to
電源
(
). To continue creating
ｃａｎｃｅｌ
P.317
P.310
s
P.134
s
P.298
• If you enter an address in [To:], you can send the
created mail without entering [Subject:] and [Text].
• You can send mail to several receivers at one
time by adding addresses.
• When [To:] is filled and you select [From add.
book], the address in [To:] is overwritten.
• Do the same procedure as "IN Mail"
check the contents of OUT Mail.
• Refer to each page for managing OUT Mail.
•
Managing with a folder
•
Deleting OUT Mail
Switch the indication method
for entered word count
You can switch the work count method
from the mail text editing screen.
1
Press
the text entry screen
2
Turn
s
, you
[text volume] and
press
Byte
Character : The number of entered characters is
s
s
P.295
P.264
s
P.282
s
P.286
(
) at
ｏｐｔｉｏｎ
Ｍｅｓｓａｇｅ
ｃｏｐｙ
Ｈａｐｐｙ Ｂｉｒｔｈｄａｙ
ｃｕｔ
ｔｏ ｙｏｕ！
ｐａｓｔｅ
区点コート゛入力
予測変換切替
予測辞書登録
▼
▼
ＰＲＥ ０２３ｃｈａｒ ＡＢａｂ
ｂａｃｋ
ｓｅｌｅｃｔ
to select
Ｔｅｘｔ ｖｏｌｕｍｅ
Ｂｙｔｅ
(
)
ｓｅｌｅｃｔ
Ｃｈａｒａｃｔｅｒ
ｃａｎｃｅｌ
ｓｅｌｅｃｔ
: The number of entered characters is
shown by "Byte Count/Word Count".
A full-width character is 2-bytes and
a half-width character is 1-byte.
shown, regardless whether two-byte
or one-byte characters.
s
to
Advertisement
