Replacing The Bbu - Infortrend S12 Series Hardware Manual

Replacing the BBU

1 5 7
To replace the BBU, follow these steps:
1. Remove the controller out of the enclosure (refer to
2. Loosen screws (1) and remove the BBU (2). For type II controller models, please
unplug the BBU power connector (indicated by the
Type I controller systems
3. For type II controller systems, to separate the BBU from
the screws shown in the following illustration.
4. Install the replacement module and fasten screws (refer to
5. Reinstall the controller (refer to
NOTE
A replacement BBU takes approximately twelve hours to charge to its full capacity.
The life expectancy of a BBU is three years.
If the cause of a failure cannot be determined even after a BBU module is
replaced, contact your system vendor.
EonStor / EonStor DS S12/S16/S24 Series
1 1
2
Installing the RAID
151
Removing the
blue circle).
2
1
Type II controller systems
the top cover, unscrew
BBU
Installing the
Controller).
Controller).
1
BBU).