Installing Controller Module(S) - Infortrend S12 Series Hardware Manual

Installing Controller Module(s)

2 1
WARNING
When inserting the controller, please make sure you apply pressure evenly on both
sides of the rear controller panel. Uneven pressure may slant the insertion angle and
damage connector pins!
Installation of the controller modules into the enclosure should only occur after the
enclosure has been rack-mounted! Please refer to the RAID Enclosure Slide Rail Kit
Installation Guide or the quick installation guide that came with the system.
Users need to observe
To install the controller module:
1. Carefully retrieve the controller module out of the carton box.
2. Gently slide the controller into the enclosure.
3. When you feel the connectors meet, push the controller levers upwards to
fully engage the controller into the enclosure.
4. Complete the controller installation by securing the two screws underneath
the lever.
EonStor / EonStor DS S12/S16/S24 Series
ESD precaution measures at all time!
53