Replacing 2Ul-Gxxxx Raid System Cooling Module - Infortrend S12 Series Hardware Manual

Replacing 2UL-Gxxxx RAID System Cooling Module

1 6 3
To replace the cooling module:
1. Snatch the retention latches towards the center, and then pull the cooling module
out of the chassis.
2. Install the replacement module by pushing it into the module bay. When fully
inserted, the retention latches will hold the module in place.
3. A firmware event will prompt shortly afterwards stating that the cooling module is
back online. The LEDs on the replacement module should not be lit when
installed.
EonStor / EonStor DS S12/S16/S24 Series
161