Power On Status Check - Infortrend S12 Series Hardware Manual

Power On Status Check

1 3 5
As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up
system. You should begin verifying system statuses via the following monitoring
interfaces:
 LEDs on LCD keypad panel: The LED on the LCD keypad panel should
illuminate after a successful initialization process, indicating that system
status is ready. System initialization and the power-on self-test may take
up to five minutes and the system fault LED may light up duri g the
process. The system fault LED will turn off after a successful boot-up
pr
 LEDs on rear chassis, including controller module, PSUs, and cooling
LCD Panel LEDs:

PWR LED: OFF

ATTN LED: OFF
Controller LEDs:

Status LED: On
(green)

C_Dirty LED: Off

Temp LED: Off

CBM Status LED: On
(green) or Off
EonStor / EonStor DS S12/S16/S24 Series
/
red amber
ocess (refer to Front Panel Components
modules (refer to System Monitoring
1
2
3
nor should you hear an audible alarm from the
).
).
4
1 2 3 4 5 6
5
6
1 2 3 4 5 6
117
n