Infortrend S12 Series Hardware Manual page 58

3. Open the hard drive tray by pressing the button
4. a. If there is a hard drive in the tray,
pull the hard drive tray about one inch
protruding out of enclosure and hold
for 30 seconds so the hard drive can
spin down. Then gently pull out the
hard drive tray out of the enclosure
and remove the four retention screws
to remove the hard drive.
b. If it is an empty tray, just gently pull the tray out of the enclosure.
5. To install the MUX board onto the hard drive tray, simply screw (circled in blue) and
secure the MUX board support plates to the end of the hard drive tray.
EonStor / EonStor DS S12/S16/S24 Series
58