Infortrend S12 Series Hardware Manual page 108

EonStor / EonStor DS S12/S16/S24 Series
There is a rotary ID switch on every
expansion enclosure
configured using a flat blade screwdriver.
Configuring enclosure IDs:

The configurable IDs for JBODs are
from 1 to 15. Usually the numbering
starts from the one closest to the
managing RAID enclosure.

Make sure a unique ID is configured on each JBOD according to the
that the SAS WWN addresses of disk drives can be properly assigned. RAID
system firmware automatically manages these addresses.
Type II Expansion connection
RAID System
Si ngle controll er systems
For 4U S48 JBODs, please refer to
con figuration an d setup
that is manually
3U JBOD
3U JBO D
.
.
.
.
.
.
.
.
.
.
4U48 JBOD
the manual th
de tails.
108
RAID System
D ual controller sy stems
at came with the system for
table so
3U JBOD
3U JBOD
.
.
.
.
.
.
.
.
.
.
4U48 JBOD