Infortrend S12 Series Hardware Manual page 159

EonStor / EonStor DS S12/S16/S24 Series
4. Install the replacement module
its lowest position so that the
onto the metal anchor pins (2) on the interior walls of the PSU slo
into chassis, and when you feel the contact resistance, pull the handle upwards
to secure the module.
Secure the PSU to the system by fastening the retention screw through the
PSU extraction handle.
Replace the power cord that connects the PSU module to the mains.
Secure the power cord connection using the included cable clamp.
. Make sure the extraction handle (1) is held at
saddle notches on the sides of the handle can snap
159
t. Push the PSU