Infortrend S12 Series Hardware Manual page 129

EonStor / EonStor DS S12/S16/S24 Series
3. Temp. Amber
4. CBM Green/
St atus Amber
5. Hst Bsy Green
6. Drv Bsy Green
7. Restore
Green
Default
of a power outage. Once the transfer is done, all
LEDs will turn off.
This signal is local to each controller.
indicates that the detected
Amber
CPU/board/chassis temperature has exceeded the
higher temperature threshold.
OFF indicates that the detected temperature reading
is within the safe range.
steady on indicates the CBM module is ready.
Green
Both a BBU and flash modules
steady on indicates CBM failure, meaning
Amber
either BBU or flash has failed. When lit, it also
indicates either BBU or a flash is missing in a
redundant-controller system.
Blinking means a BBU is being charged.
OFF means BBU is not installed in a single-controller
"G" model.
to indicate
Blinking Green
to indicate traffic on the drive
Blinking G reen
channels.
indicates the RAID configuration default has
Green
been successfully restored. The LE
invalidated after a few seconds.
129
are present.
traffic on the host bus.
D state will be