Infortrend S12 Series Hardware Manual page 164

EonStor / EonStor DS S12/S16/S24 Series
2. Unlock the drive tray bezel (indicated by the
flat-blade screwdriver to set
3. Open the drive tray. Press the button. The spring handle will pop out.
4. Remove the drive tray. Pull the tray one inch away from the enclosure. Wait for
at least 30 seconds for the disk drive to spin down, and then gently withdraw the
drive tray from the chassis.
5. Remove four retention screws (two on each side). The screws secure the hard
drive to the drive tray (indicated by the
Hard drive screw locations without mux board
Hard drive screw locations with mux board
blue
the bezel lock from lock to the un-lock position.
blue arrows).
164
arrow) by using a small