Infortrend S12 Series Hardware Manual page 105

EonStor / EonStor DS S12/S16/S24 Series
JBODs and Corresponding RAID Systems
RAID Models
S12F-S2840N
S12E-G1xxx
S12x-G2xxx
S16E-G1xxx
S24F-G1xxx
S16x-G2xxx
S24x-G2xxx
S12F-R2840N
S12x-R1xxx
S12x-R2xxx
S16F-R1xxx
S24F-R1xxx
S16x-R2xxx
S24x-R2xxx
There is a rotary ID switch on every
expansion enclosure
configured using a flat blade screwdriver.
Configuring enclosure IDs:

The configurable IDs for JBODs are
from 1 to 15. Usually the numbering
starts fro m the one closest to the managing RAID enclosure.

Make sure a unique ID is configured on each JBOD so that the SAS WWN
addresses of disk driv
automatically manages these addresses.
2U JBOD 3U JBOD
S12S-J2000SN X
S12S-J1000-G S16S-J1000-S1
S12S-J2000-G X
S16S-J1000-S /
X
S16S-J1000-S1
X S16S-J2000-S
S12S-J2000RN X
S12S-J1002-R S16S-J1000-R1
S12S-J2000-R X
S16S-J1000-R /
X
S16S-J1000-R1
X S16S-J2000-R
that is manually
es can be properly assigned. RAID system firmware
105
Configuration
Single-controller; single path
Dual-controller; fault-tolerant paths