Node Status Checking; Check Led Status Of Front Panel/Power Supply - Infortrend EonStor CS Series Installation Manual

1-5. Node Status Checking


Connect the bundled power cords to the power sockets of the system (A).

Turn on the networking devices and the expansion systems.

Press the start button to turn on CS system (B).
You can observe the LEDs located at the front panel/power supplies at the rear of the enclosure/on drive
tray. Wait until all LEDs turn into normal status without red/amber lights (Please check LED status for each
part in the following section). If the LED color is still in red/amber for more than 3 minutes after powering
up, please check the following diagnostic guide.

Check LED status of front panel/power supply.

The following table shows the status of CS front panel LED, the system works normally with
, and remain green light.
Installation Guide
EonStor CS Installation Guide
CS front panel LED
, ,
page 19 / 86