Power On Status Check
As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up
system. You should begin verifying system statuses via the following monitoring
interfaces:
LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to
Controller LEDs:
1.
Ctrl Status LED: On (green)
2.
C_Dirty LED: Off
3.
Temp LED: Off
red
/
amber
nor should you hear an audible alarm from the
System
Monitoring).
4.
5.
6.
1 2 3
4 5 6
89
CBM Status LED: On (green) or
Off (if not installed)
Hst Bsy LED: On (green)
Drv Bsy LED: On (green)