Power On Status Check - Infortrend EonStor GS 3000 Series Hardware Manual

NOTE
Make sure all power supply modules' switches are turned on!

Power On Status Check

As a general rule, once the system has been powered on, there should NOT be
LED(s) that light up
system. You may verifying system statuses via the following monitoring interfaces:
 LEDs on rear chassis, including controller module, PSUs, and cooling
modules (refer to System Monitoring).
Controller LEDs:
1. Ctrl Status LED: On (green)
2. CBM Status LED: On (green)
or Off (if not installed)
PSU & Cooling Module LEDs:
PSU LED: On (green)
Green
red / amber nor should you hear an audible alarm from the
3.
4.
83
C_Dirty LED: Off
Hst Bsy LED: On (green)